purefil Kerfil Aluminiumoxid 1 kg 1.75 mm

Kerfil filaments consist of a ceramic powder and a thermoplastic binder system. Kerfil filaments are flexible and can be processed with all standard FDM 3D printers. In order to obtain a pure ceramic part, the printed parts (green parts) still have to be debound and sintered.
In a first debinding step, the binder material is dissolved out using acetone. In a further step, the remaining binder material is thermally debound. Sintering then takes place at approx. 1500°C.
In the end, a fully-fledged ceramic component is created with a density of up to 99%. Further information on processing, debinding and sintering of the molded parts can be found in the technical data sheet.

- Extremely high hardness - Heat resistance well over 1000°C
- Full ceramic parts
- very little wear
- low coefficient of expansion
- Corrosion resistant
- very good biocompatibility

Material: alumina

Diameter: 1.75 +/- 0.05mm

Weight: 1kg

Nozzle temperature: 170-200 ° C

Printing table temperature: 50 ° C